Installation time and costs are reduced by easy power and control wiring.
All units are factory-wired, piped, charged, and tested prior to shipment.
Factory-installed options such as stainless steel heat exchanger, electric heating elements, supply and return air smoke detectors, disconnect switch, powered or non-powered GFI convenience outlet, single enthalpy economizer, power exhaust, high static drive blower motor, phase monitor, coil guard, dirty filter switch, hinged filter door, and toolless access panels further reduce installation costs.
BAS factory mounted controls include Novar, Honeywell, Johnson, and CPC.
Gas and electric utility knockouts are provided on unit side and bottom for easy connections.
Convertible airflow design means no panel cutting is required.
Wide range of indoor airflows using belt-drive blowers.
Durable finish, made of powder-painted, galvanized steel to meet 750-hour salt-spray test demands.
Full-perimeter base rails are permanently attached to provide a solid unit foundation.
Compressor is internally protected against high pressure and temperature.
Grooved copper tubes and enhanced aluminum- fin construction improve heat transfer.
Heat exchangers are corrosion-resistant, with aluminized steel tubular construction for durability and long service life.
Permanently lubricated condenser and evaporator fan motor bearings need no annual maintenance.
Complete line of field-installed accessories, propane and high-altitude conversion kits, smoke detectors, CO2 sensors, motorized dampers, single enthalpy economizers, and dual enthalpy sensors are available.